After multiple rounds of simulation and process testing, the optimized weight of the stacking bucket design for MEPER BLOW MOLDING reached 800 grams, a 24% reduction from the initial design of 1050 grams.

Calculated based on an annual output of 7 million stacking barrels, this means:

Save approximately 1750 tons of HDPE material annually;

Reduce approximately 4000 tons of carbon dioxide emissions annually, depending on the resin grade and source;

The cost-effectiveness is significant, with considerable long-term economic impact, and the reduction in logistics weight and energy consumption will further amplify this benefit.

MEPER BLOW MOLDING has conducted extensive testing and verification, and the lightweight stacking bucket has achieved or exceeded the mechanical performance of its predecessor products

The drop test shows that the energy absorption capacity is equivalent or slightly improved;

The stacking test confirmed the long-term stability for 28 days;

The top pressure test shows a lower degree of deformation.

These results convey a clear signal: smart design is better than simply stacking materials.